Your shopping cart is empty!
Your shopping cart is empty!
Your shopping cart is empty!
An Apple Watch Skin is a perfectly fitting wrap for your Apple Watch device, protecting it from scratches and annoying fingerprints. Additionally, you can customize it to stand out from other Apple Watches in the market. Check out all the models in the Saveskinz shop; you'll love them.
Apple Watch Skins are really easy to use. Just prepare the surface of your Apple Watch with a general cleaning and install the skin specifically for your device. We recommend that you check your Apple Watch model before purchase.
You can, of course, remove the Apple Watch Skin without any residues at any time. You can change the design whenever you want without leaving marks on your device. No trace of adhesive, no scratches, 100% in perfect condition as before.
Step 1: Clean and dry the surface of your Apple Watch.
Step 2: Choose a polishing tool. A credit card, a gift card, or a blunt plastic customer card are suitable.
Step 3: Lay your Apple Watch flat in front of you - with the opening facing you and the laptop completely closed.
Step 4: Slowly peel the protective film from two corners along one of the longer edges of the sticker.
Step 5: While keeping the sticker tight, align its edge with the edge of your phone and stick it lightly.
Step 6: Use a credit card to smooth out the top of the sticker, pushing out and smoothing any air bubbles. (Note that most of the protective film is still attached to the sticker at this point).
Step 7: Continue to peel off the backing in small steps (1-2 inches), smoothing it out with a credit card as you go.
Step 8: When you reach the end, ensure that the corners are aligned. Starting with one corner, press down with your finger on the corner/pieces of the corner and gently and completely remove the protective film from that side of the sticker - continue peeling until it's entirely off. Apply pressure to the opposite corner to fully secure the decal.
Step 9: If one or more corners/edges aren't fully secured, heat them with a hair dryer from a distance of at least 5 cm for no more than 3 seconds per corner.
Saveskinz is a small company from Salzburg that specializes in producing high-quality skins for Apple Watch and other devices using ultra-premium materials from market leaders 3M and Orafol. We place the utmost importance on quality, uniqueness, and customer satisfaction.
